Installing the Operating System with Express Setup 5-11
6.
Select the operating system to install.
Select [Install the Windows (32bit editions)] from the menu and click [Next].
7.
Enter the logical drive settings.
The [Enter RAID settings] steps are displayed. Confirm the parameters, modify if
necessary, and then click [Next].
NOTES:
You can use only the physical devices that have the same model
number to configure a logical drive.
If the process does not complete normally, the driver may not be
stored in EXPRESSBUILDER. Refer to "Optional Board
Supported by NEC EXPRESSBUILDER" described earlier in this
chapter.
To Next Page
Loading...
