NEC BladeServer Express5800 Series - Installing and Setting Device Drivers; Proset

5-18 Installing the Operating System with Express Setup
INSTALLING AND SETTING DEVICE DRIVERS
Follow these steps to install and configure the device drivers.
PROSet
NOTE: All of the following operations must be performed by a user
with administrator privileges. Operation by [Remote Desktop
Connection] is prohibited.
When viewing the adapter teaming settings in the adapter properties
dialog box, click [Cancel] if you have not made any changes. Clicking
[OK] may cause temporary loss of network connectivity.
PROSet is a utility that configures and monitors the functions of the network adapter.
PROSet provides the following functions:
 Detailed adapter information.
 Diagnosis by using loopback and packet send tests.
 Teaming configuration.
Configuring several network adapters as one team provides a fault-tolerant networking environment
and enhances throughput between the switches.
PROSet is necessary to utilize these features.
Follow the procedure below to install PROSet:
1. Insert the NEC EXPRESSBUILDER DVD into the optical disc drive.
If the autorun menu appears, close the menu screen.
2. Open [Windows Explorer].
Click [Start], click [Programs], click [Accessories], and click [Windows Explorer].
3. Run "dxsetup.exe" in the following directory:
\001\win\winnt\dotnet\ns41s\proset\2kxpws03
The [Intel(R) PROSet - Install Shield Wizard] starts.
4. Click [Next].
5. In the [License Agreement] window, select [I Accept the terms in the license agreement].
6. Click [Next].
7. Select [Complete] and click [Next].
8. Click [Install] to begin the installation and then click [Finish] in [InstallShield Wizard
Completed].
9. Restart the system.