Setting Up Your Server 3-5
MAKING CONNECTIONS
Connect peripheral devices to the CPU blade.
IMPORTANT:
Contact the maintenance engineer or your service representative for
information on configuring an uninterruptible power supply system
or auto power controller and the time schedule operation.
If you are installing the CPU blade in the Blade Enclosure
(SIGMABLADE), follow the instructions described in the User's
Guide of the Blade Enclosure.
WARNING
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages 1-2
to 1-6 for details.
Do not hold the power plug with wet hands.
Do not connect earth lines to any gas tubes.
CAUTION
Observe the following instructions to use the server safely. Failure to follow
these instructions may cause a fire, personal injury, or property damage. See
pages 1-2 to 1-6 for details.
Do not plug the power cord in to an improper power source.
Do not connect the power cord to an outlet that has an illegal number of
connections.
Insert the power plug into the outlet as far as it goes.
Use the authorized power cord only.
Do not connect or disconnect any interface cable with the power cord of the
server plugged into a power source.
Do not use any unauthorized interface cable.
To Next Page
Loading...
