EasyManua.ls Logo

NEC BladeServer Express5800 Series - Installing DIMM

NEC BladeServer Express5800 Series
292 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Setting Up Your Server 3-3
CPU unit:
When the number/letter of the last character is an even number or A, C, or E:
The MAC address for LAN port 3 is as described on the label.
The MAC address for LAN port 4 can be obtained by adding 1 to the MAC address.
When the number/letter of the last character is an odd number or B, D, or F:
The MAC address for LAN port 3 can be obtained by adding 1 to the MAC address.
The MAC address for LAN port 4 can be obtained by adding 2 to the MAC address.
The MAC addresses can be checked by using a Windows or Linux command.
Windows
Enter "ipconfig /all" in the MS-DOS prompt or from [Run] in the Start menu to see the
indicated physical address part.
Linux
Enter "ifconfig" in the prompt to see the indicated "Hwaddr."
Installing DIMM
If your CPU blade is not equipped with memory, install DIMM’s according to Chapter 9.
Two DIMMs must be populated in a pair.

Table of Contents

Related product manuals