NEC BladeServer Express5800 Series - Standard Features

General Description 2-3
STANDARD FEATURES
High performance
Expandability
 Dual-core Intel ® Xeon ® Processor
Quad-core Intel
® Xeon ® Processor
 DDR2-667 SDRAM FB-DIMM
 High-speed 1000BASE-T interface x4
(1Gbps supported)
 High-speed disk access (SAS)
 Four mezzanine card slots
 48GB maximum memory capacity
 Up to two processors
 Four network ports
 Up to six hard disk drives (SAS 2.5-inch)
 Two USB 2.0 interface ports
High
-
reliability
 Memory monitoring feature (correction of
correctable error/detection of
uncorrectable error)
 CPU degradation feature (logical
isolation of a failed device)
 Bus parity error detection
 Temperature detection
 Error notification
 Internal voltage monitoring feature
 BIOS password feature
 Auto-rebuild feature (hot-swappable)
Management Utilities
Available Features
 NEC ESMPRO
 NEC DianaScope
 Remote monitoring feature
(EXPRESSSCOPE engine)
 Software power-off
 Remote power-on feature
 AC-Link feature
Maintenance Feature
s
Self
-
diagnosis
 Off-line Maintenance Utility
 Memory dump feature using the DUMP
switch
 Power On Self-Test (POST)
 Test and Diagnosis (T&D)
Easy Setup
 NEC EXPRESSBUILDER (system
management tools)
 SETUP (BIOS setup utility)
 Disk array configuration utility