B-18 Installing the Operating System
Graphics Accelerator
The driver for the standard graphics accelerator will be installed automatically. The following
procedure describes how to install it manually:
1.
Insert the NEC EXPRESSBUILDER DVD into the DVD-ROM drive.
2.
Click [Start], click [Programs], click [Accessories], and click [Windows Explorer].
3.
Run "SETUP.EXE" in the following directory:
\001\win\winnt\dotnet\video\matrox\setup.exe
Windows Server 2003 x64 Editions:
\001\win\winnt\w2k3amd\video\matrox\setup.exe
4.
Follow the messages to continue the installation.
If the dialog message "Digital Signature could not been found" appears, select [Yes] to
continue.
5.
Remove the NEC EXPRESSBUILDER DVD from the DVD-ROM drive and restart the
system.
Fibre Channel Controller Driver
If you use the FibreChannel Controller (N8403-018), update your system with the NEC
EXPRESSBUILDER DVD.
The Fibre Channel Controller driver will be installed automatically.
NOTE:
This procedure is the same for Windows Server 2003 x64
Editions and Windows Server 2003.
To Next Page
Loading...
