NEC BladeServer Express5800 Series - Remote Desktop for Management

Installing the Operating System B-13
REMOTE DESKTOP FOR MANAGEMENT
This section describes the necessary configuration settings of the Remote Desktop for Management
for Windows Server 2003 x64 Editions or Windows Server 2003.
IMPORTANT: The license for Sever Client Access is not needed to
use the Remote Desktop for Management.
The Remote Desktop for Management provides two connections
simultaneously.
Windows Server 2003 x64 Editions
The configuration procedure is as follows:
IMPORTANT: Set the password for the Administrator account in
order to use the Remote Desktop for Management.
1. Click [Start], click [Control Panel], and then open [System].
2. Click the [Remote] tab, check [Allow users to connect remotely to this computer], and
then click [OK].
Windows Server 2003
The configuration procedure is as follows:
IMPORTANT: Set the password for the Administrator account in
order to use the Remote Desktop for Management.
1. Click [Start], click [Control Panel], and then open [System].
2. Click the [Remote] tab, check [Allow users to connect remotely to this computer], and
then click [OK].