EasyManua.ls Logo

NEC BladeServer Express5800 Series - Problems with Express Setup

NEC BladeServer Express5800 Series
292 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8-18 Troubleshooting
Problems with Express Setup
The system partition size issmaller than the specified value:
In Express Setup, there are some cases where the system partition size is c about 8MB
smaller than the specified size.
It is not a problem for normal system operation.
The following message appears when you try to specify a partition size larger than the
capacity of the hard disk drive:
The creating of the partition was failed.
The process can not be continued. The process was stopped.
O K
Cannot continue setup.
Specify a partition size smaller than the capacity of the hard disk drive and retry
setup.
Specified to join the Domain, but the system is installed as Workgroup:
When the setup fails to join the domain during the installation, it will install the
system as Workgroup. Open [System] in Control Panel to join the domain.
Unable to configure the Network adapter:
In Express Setup, you cannot configure the Network adapter. Configure it in the
Control Panel after starting Windows.

Table of Contents

Related product manuals