NEC BladeServer Express5800 Series - Setup of Device Driver (Normally Installed in Server; Network Driver

B-14 Installing the Operating System
SETUP OF DEVICE DRIVER (NORMALLY INSTALLED IN
SERVER)
For the installation and setup of each optional device driver, refer to the documentation provided
with the device.
Network Driver
The two network drivers for the standard equipment are automatically installed.
However, the transfer rate and duplex mode of each network driver must be set.
When the system is Windows Server 2003 x64 Editions
[When PROSet is not installed]
1. Open [Local Area Connection Properties].
1. Click [Start], click [Control Panel], click [Network Connections], and click [Local
Area Connection].
2. Click [Configure].
The properties dialog box for the network adapter appears.
3. Click the [Advanced] tab and specify [Link Speed & Duplex] values that match the hub.
4. Click [OK].
[When PROSet is installed]
1. Open [Device Manager]
2. Double-click [(Network Adapter Name)] in the list.
3. Click the [Link] tab and specify [Speed & Duplex] values that match the hub.
4. Click [OK].