6-10 Installing and Using Utilities
7.
Enter the logical drive settings.
The [Enter RAID setting] steps are displayed. Confirm the parameters, modify if
necessary, and then click [Next].
IMPORTANT: "The number of the total physical devices displays the
upper limit of devices that the RAID controller can support.
The total of "The number of physical devices used to create the logical
drive" and "The number of the physical devices specified as the hot
spare" must not exceed "The number of the total physical devices"
connected to the system.
NOTE: You can use only the physical devices that have the same
model number to configure a logical drive.
To Next Page
Loading...
