NEC BladeServer Express5800 Series - Page 222

Troubleshooting 8-29
NOTE:
The following BIOS settings will be set as shown below:
 LAN Controller: [Enabled]
 Serial Port A: [Enabled]
Base I/O Address: [3F8]
Interrupt: [IRQ 4]
 Serial Port B: [Enabled]
Base I/O Address: [2F8]
Interrupt: [IRQ 3]
 BIOS Redirection Port: [Serial Port B]
 Baud Rate: [19.2K]
 Flow Control: [CTS/RTS]
 Console Type: [PC ANSI]