Installing the Operating System B-11
9.
If an optional device is installed, select the proper driver and press Enter.
– Emulex LPX000 PCI Fibre Channel HBA
(When Fibre Channel controller (N8403-018) is used).
10.
When the following message is shown, press Enter to start "Welcome to Setup."
11.
When the installation of Windows Server 2003 finishes, the system reboots automatically.
12.
When Windows Server 2003 R2 is installed, the [Windows Setup] screen will be
displayed after logging on to the system.
IMPORTANT:
The [Windows Setup] screen may not be displayed.
Be sure to install Microsoft Windows Server 2003 R2 DISC 2
according to the following procedures.
You can install Microsoft Windows Server 2003 R2 DISC 2 after the
application of "System update". Be sure to install Microsoft
Windows Server 2003 R2 DISC 2. In this case, note that the
[Windows Setup] screen is not displayed.
13.
Insert the Microsoft Windows Server 2003 R2 DISC 2 CD-ROM into the DVD-ROM
drive.
Confirm the parameters and click [OK].
14.
When the installationfinishes, remove the Microsoft Windows Server 2003 R2 DISC 2
CD-ROM from the DVD-ROM drive and restart the system.
15.
After installation is complete, be sure to execute the tasks described in "Setup of Device
Driver (Normally Installed in Server)" and "Updating the System" of this chapter.
To Next Page
Loading...
