NEC Dterm DTZ-8R-1 - Page 30

Issue 1.0
3-2 Installation
To connect the telephone cords:
1. Connect one line cord from NEC’s PBX (or key system) digital station port to
the Line In connector on the D
term
Cordless DECT base unit. Connect another
line cord from the Line Out connector to a qualified D
term
multiline telephone.
Figure 3-1 Connecting Telephone Cords
NOTE

Do not connect the DTZ-8R-1 line cord directly to PBX station card as the
DTZ-8R-1 will not function. Connect the line cord to the jack with a single
pair connected back to one digital station port.
Line In
To PBX (or key system)
digital station port.
Line Out
Connect to the desk
phone.