Issue 1.0
Owner’s Manual 3-7
SECTION 7 INSTALLING THE HANDSET BATTERIES
Before installing batteries, refer to Chapter 1 Specifications and Safety Information,
Section 3 Battery Safety on page 1-4. It is important to follow safety regulations
when handling batteries.
1. Remove the battery cover by pressing the latch and sliding the cover down and
off of the handset.
2. Install the two AAA batteries (AAA Ni-MH, 1.2V, 900mAh re-chargeable
batteries), observing the polarity orientation.
Figure 3-7 Removing the Battery Cover
Batteries must be the same size and type (AAA Ni-MH, 1.2V, 900mAh re-
chargeable batteries. Use of other battery types may be hazardous and
will void the product warranty.
Figure 3-8 Installing the Batteries
To Next Page
Loading...
