NEC Dterm DTZ-8R-1 - Redial (Option); Autostandby

Issue 1.0
Owner’s Manual 6-15
2.6 Redial (Option)
When the RF link is established between the handset and the base station, you
can press the REDIAL key. The last number dialed is shown and the digits dialed
are sent to the base station.
Example:
(1) [talk][1][2][3][talk] redial: 123
(2) [talk][1][2][3]……….[1][2][talk] (over 32 digits) redial: 123……12
(up to 32 digits)
(3) [talk][1][2][3][F1][4][5][6][talk] redial: 123
2.7 AutoStandby
®
When the handset is in one of the modes listed below, placing the handset on the
charger changes it to Standby mode. At this time, a confirmation tone is emitted.
 Ringer Volume Setting
 Menu Setting
 Ta l k M o de
 Trying to Connect to the Base Station
NOTE

❍ An error tone is emitted when redial is empty.
❍ Dial limit is 32 digits, redial stores up to 32 digits in memory.
❍ Redial data is stored in handset memory (EEPROM).
❍ If F1~F12 keys are pressed, the number dialed before the Function key
is pressed will be stored in redial memory.