NEC Dterm DTZ-8R-1 - Setup and Operation; Initial Setup and Programming

Owner’s Manual 6-1
Chapter 6
Setup and Operation
SECTION 1 SETTING UP AND PROGRAMMING THE DTZ-8R-1
1.1 Programming Mode
1.1.1 Training Mode (Entry)
To enter Training mode:
Press and hold
*
and # at the same time and then press the TALK key. The
handset emits a confirmation tone and enters Training mode. The following
message is displayed on the LCD and the F1 LED blinks.
IMPORTANT
The screens in this section are system-dependent and may not match your
handset.