NEC Dterm DTZ-8R-1 - Page 46

Issue 1.0
6-2 Setup and Operation
1.1.2 Training Mode (Next Key [Softkey1] – Select Item)
To select an item:
Press the Next key.
1.1.3 Training Mode (Func Key [Softkey2] – Change Item)
To change an item:
Press the Func key.
1.1.4 Training Mode (Back Key [Softkey4] – Exit from Training Mode)
When the Back key is pressed while in Training mode, a key touch tone is
emitted and a ‘Training off’ command is sent to the PBX. The handset exits
Training mode.
1.1.5 Training Mode (Volume Up Key – Change Each Item Setting)
The up key can change each item setting as illustrated in the following
displays (e.g., when the F1 setting is changed, the F1 LED blinks).
The items in the display change in the following
sequence:
F1
F1(TALK)F2F2(TALK)F3F3(TALK)
F4F4(TALK)F5F5(TALK)F6F6(TALK)
F7
F7(TALK)F8F8(TALK)OFF HOOK
RING
F1…
The items in the display change in the following
sequence:
LK01
LK02LK03LK04LK05LK06
LK07LK08LK09LK10LK11LK12LK13
LK14LK15LK16LNRSPDRecallFNC
ANSLK01…