NEC Dterm DTZ-8R-1 - Page 33

Issue 1.0
Owner’s Manual 3-5
2. Plug the AC adapter (yellow tip) into the base unit, and route the cord
through the molded channel on the back of the base unit.
3. Plug one end of the short telephone cord (locally supplied) into the LINE
jack on the base unit. If the NEC multiline (wired) phone is used,
connect a line cord from the LINE OUT jack on the base unit to the
multiline phone.
4. Place the base unit on the posts of the wall screws and push down until
it is firmly seated.
5. Plug the other end of the short telephone cord into the telephone wall
jack.
6. Plug the AC adapter into a standard 120 VAC wall outlet.
Figure 3-4 Attaching the Base Directly to the Wall
9
/
6
4
i
n
3
-
5
/
1
6
i
n
WARNING
Do not use an outlet controlled by a wall switch.