NEC Dterm DTZ-8R-1 - Base Unit Controls and LED Indicators

Issue 1.0
Owner’s Manual 4-3
The Base Unit has three LEDs. The operation status of the LEDs are listed below.
Power LED
 Base is powered on: On (Blue LED)
 Base is powered off: Off
Cordless Telephone LED
 Cordless Phone Operation: On
 Desk Phone Operation: Off
Desk Phone LED
 Cordless Phone Operation: Off
 Desk Phone Operation: On
Ringer Volume To adjust the ringer volume press the Volume softkey (in Standby mode),
then use the Up/Down arrow keys to adjust the ringer volume. You can
choose from four different settings:
 OFF-Vibrate
 Low
 Medium
 High
The LCD displays the current volume setting for two seconds.
 If Ringer is set to OFF-Vibrate, it will not vibrate when in the charging
cradle.
Volume
During a conversation, use the Up/Down arrow keys to adjust the handset
receiver volume.
Headset Jack Insert the Headset plug into the headset jack Use corresponding handset
keys to activate headset.
Table 4-1 Handset Control Functions (Continued)
Condition Action
VOLUME