4-42
3. Select ID-2/3 hard disks.
Same as for Channel-1 for ID-0/1, press Space in the status described in 2 to select Channel-1 for ID-2/3 and
then press
Enter to determine the selection. ("ONLIN A02-01/02" is then displayed.)
4. Set logical drive.
Pressing F10 in the status described in 3 displays a screen shown below. Set each item. Then select "Advance
Menu" to display the "Advanced" sub menu screen.
The setting contents are shown below:
Setting item Default (initial value) Setting range
RAID 1 0, 1
Size Full capacity (logical drive) Full capacity
Stripe Size 64 KB 2/4/8/16/32/64/128
Write Policy WRBACK WRTHRU
WRBACK
Read Policy NORMAL NORMAL
READAHEAD
ADAPTIVE
Advanced
Cache Policy Direct IO Direct IO
Cache IO
Span YES CANSPAN (YES)
NOSPAN (NO)
– To open the "Advanced" sub menu screen from the "Logical Drive XX" menu screen, select "Advanced
Menu" and then press
Enter. Press Esc to move to the "Logical Drive XX" menu screen. In this case, the
cursor moves to "Accept."
To Next Page
Loading...
