G-19
STEP 1 INSTALLING COMPONENTS ON RACK
Install the slide rail assembly on the rack in the following procedure:
1. Locate the positions on which the slide assembly is installed by using the template.
The template shows the positions on which the rails and core nuts are installed.
2. Install the core nuts at the points identified by the template.
Install the core nuts on the inner side of the rack. On the front face, install two core nuts, which are attached to
the rack, at each of the right and left ends.
On the rear face, install two core nuts, which are attached to the rack, at the right end.
For each core nut, hang either of the top and bottom clips on an angle hole of the rack and the other clip on
the other hole by using a tool such as a flathead screwdriver.
IMPORTANT: Make sure that the core nuts installed at the right and left sides of the front
and rear ends of the rack are on the same level.
3. After removing the screw located on the rear right of the server, install the adapter bracket with the screw
removed before.
To Next Page
Loading...
