8-53
OFF-LINE MAINTENANCE UTILITY
The Off-line Maintenance Utility is an operating system independent maintenance program. When you are unable to
start the operating system dependent ESMPRO to troubleshoot a problem, the Off-line Maintenance Utility can be used.
IMPORTANT:
The Off-line Maintenance Utility is intended for use by your service representative. The
EXPRESSBUILDER CD-ROM and the Off-line Maintenance Utility Bootable floppy
disk you have created contain a file that describes operation of the utility, but do not
attempt to use the utility by yourself. Contact your service representative and follow
instructions.
Starting the Off-line Maintenance Utility disables any access from a client to the server.
Starting the Off-line Maintenance Utility
The Off-line Maintenance Utility may be started in the following ways.
From the CD-ROM
Insert the EXPRESSBUILDER CD-ROM in the CD-ROM drive and reboot the system.
After the menu is displayed on the screen, select "Tools" - "Off-line Maintenance Utility".
The Off-line Maintenance Utility program starts from the CD-ROM.
From the floppy disk
Insert the Off-line Maintenance Utility Bootable floppy disk in the floppy disk drive and reboot the system.
The Off-line Maintenance Utility program starts from the boot disk.
The Off-line Maintenance Utility Bootable floppy disk is created by selecting "Tools" - "Create Support FD"
on the EXPRESSBUILDER.
Manual start (by pressing F4)
When the Off-line Maintenance Utility is installed, press
F4 while the start-up screen of the server is on
screen. The Off-line Maintenance Utility starts from the hard disk.
To Next Page
Loading...
