NEC Express5800 140He - Front View (Switch and LED Panel)

2-5
Front View (Switch and LED Panel)
1 POWER switch
The power switch is used to turn on/off the power. If you the POWER/SLEEP lamp
goes on and the power is turned on. If you press the switch again, the power is turned off. The system is forcibly
shut down when the power switch is pressed continuously for four seconds or longer.
2 RESE
e r reset the server.
3 LE
yo
switc
4 D
es e front panel and the rear panel on and off.
5 POW
6 A
7 DISK
8 AN
9 AN
10 D
11 UM
12 oc
13 em
14 b
15 w
16 n
17 er
18 DUM
e llect the event logs having occurred in the server.
19 CLE
press the switch once, then
T switch
eset switch is used to
Th
S
If
EP switch
u press the sleep switch once, the server enters into the sleep state (power saving mode). If you press the
h again, the server recovers to the normal state. Windows Server 2003/Windows 2000 support this feature.
UI
Pr
(Unit ID) switch
sing the UID switch turn
s UID lamp (blue) located on th
ER/SLEEP lamp
ST TUS lamp
ACCESS lamp
1 access lamp
2 access lamp
L
L
UI
(Unit ID lamp)
D P lamp
Pr essor board error lamp
mp
M
I/O
ory board error la
oard error lamp
Po er unit error lamp
Fa error lamp
Th mal error lamp
P switch
sed to co
Th dump switch is u
AR switch
11 to 17 from left
18
1
5 to 10 from left
19
2 3 4