9-42
Memory Board
To install or remove a DIMM, remove the memory board first.
One memory board is factory-installed in the server. Up to four memory boards (32 GB maximum) can be installed in
the server.
The failing DIMM or memory board can be hot-swapped (replacement with power-on state) in the memory RAID
configuration. For hot-swap memory board, see "Memory Hot-Plug Feature 1 (Hot Replace)" and "Memory Hot-Plug
Feature 2 (Hot Add)" described later in this chapter.
Memory board slot #3
(for additional memory
board)
Memory board slot #4
(for additional memory
board)
Memory board slot #2
(for additional memory
board)
Memory board slot #1
(for factory-installed
memory board)
y board installation order: #2 → #3 → #4
Memor
To Next Page
Loading...
