4-31
MegaRAID Configuration Utility: TOP menu (Management Menu) screen
NOTE: In some cases, the following display appears in the POST screen after replacing
the I/O board. This indicates that both the disk array controller and hard disk have
configuration information, and they do not match. (Shown below is a sample display.)
Exiting from MegaRAID Configuration Utility
Press Esc in the TOP menu of MegaRAID Configuration Utility.
When a confirmation message appears, select [Yes].
When the above message appears, press
Ctrl+Alt+Delete.
The server is rebooted.
Menu Tree
Setting list
+: Selection/execution parameter : Setting parameter. •: Information display
>: Can be set (modified) after creation of logical drive, #: Cannot be executed
Menu Description
+Configure
Performs Configuration settings
+Easy Configuration Set configuration (Using fixed value)
+New Configuration Set new configuration
+View/Add Configuration Additional setting / viewing configuration
+Clear Configuration Clear configuration
+Specify Bootable Logical Drive Chose Bootable Logical Drive
+Initialize
Initialize logical drive
+Objects
Various settings
To Next Page
Loading...
