NEC Express5800 140He - Page 106

4-32
Menu Description
+Adapter Set disk array controller
+Clear Configuration Clear configuration
*1 FlexRAID PowerFail Set whether to restart after rebuilding
*2 Fast Initialization Set high-speed initialization
*3 Disk Spin up Timing Set hard disk spin-up
*4 Cache Flush Timing Set cache flush timing
*5 Rebuild Rate Set rebuild rate
*6 Alarm Control Set alarm sound (ON / OFF)
+Other Adapter Information Board information display (FW version, etc.)
• FW Supports
FW type
• FW Ver
FW version
• BIOS Ver
BIOS version
• DRAM
Memory capacity
• Adapter Type
Board series NO.
+Factory Default Set default value
*7 Disable (Enable) BIOS Set BIOS Enable / Disable
+Battery Information Battery information
• Backup Module
Existence of battery module
• Battery Pack
Existence of battery pack
• Temperature
Battery temperature
• Voltage
Battery voltage
• Fast Charging
Set fast charging status
• No of Cycles
The number charge cycle
+Reset Battery Charge Counter Clear battery charge counter
+Other Adapter Options Adapter detailed options
*8 Emulation Set control mode
*9 Auto Rebuild Set auto rebuilding Enable / Disable
• Initiator ID
Indicate Initiator ID No.
*10 Cluster Mode Set cluster mode
*11 Multiple PCI Delayed Trans Set PCI bus bridge
*12 Force Boot Forced setting of configuration information(HDD)
*13 Coercion Algorithm Setting parameter for maximum hard disk capacity
Abort BI & CC Activities Abort Background initialize or Check Consistency
*14 CC Restoration Select CC Restoration mode
*15 Temporary Offline RAID Set Temporary offline Enable / Disable
+Logical Drive Logical drive operation
+Logical Drives Select logical drive
+Initialize Initialize logical drive
+Check Consistency Check logical drive redundancy
+View/Update Parameters Display logical drive information
• RAID
Display RAID level
• SIZE
Display logical drive capacity
• Stripe SIZE
Display stripe size
+√ Write Policy
Set write mode
+√ Read Policy
Set read mode
+√ Cache Policy
Set cache mode
+√ FlexRAID Virtual Sizing
Set virtual sizing Enable / Disable *Do not set to Enable
• #Stripes
Display stripe size
• State
Display logical drive status
+Physical Drive Physical drive menu
+Physical Drive Selection Menu Physical drive operation
+Rebuild Perform rebuilding
+Format Perform low level format
*Do not use
+Make Online Set the disk online