G-14
Removing Top and Side Covers
Remove the top and side covers in the following procedure:
1. Place the server slowly and carefully so that the left side of the server faces upward.
2. Remove a screw using the Phillips screwdriver.
3. Slide the top cover toward the rear of the server. Then lift the cover to remove it.
4. Slide the side cover toward the front of the server. Then remove the side cover.
IMPORTANT: Keep the removed screws and covers for future use.
Top cover
Side cover
CAUTION
Note sufficiently that your fingers or hands may not be caught in bottom of the
server when replacing the server or removing screws and pedestals from the
server. Doing so may cause a personal injury.
To Next Page
Loading...
