3-3
SELECTING A SITE
Re ing a suitable site for your server. The following describes installation of
the server and connections to the server.
ad the following precautions before select
CAUTION
Observe the following instructions to use follow these instructions
may cause a fire, personal injury, or property 3 to 1-8 for details.
the server safely. Failure to
damage. See pages 1
-
Neve
Do n
r attempt to lift the server with three or less persons.
ot install the server in any place other than specified.
The foll ustra
owing figure ill tes a site suitable for installing the server.
When you hav
then place it
e selected a server site, hold the server by its bottom with at least four persons and carry it to the site,
slowly and gently.
IMPORTANT: Do not hold the server by its front door to lift the server. The front door
may be disengaged and damage the server.
* It is recommended that the server should be used in a room where
temperature is in the range between 15 to 25ºC.
Close enough to
connect the mouse
and the dis
.
Install the server on the
floor or rigid, flat desk.
Clean and tidy room
Room that satisfies the fo ing
conditions for operation: *
Temperature: 10 to 35ºC
llow
Humidity: 20 to 80% (no
condensation)
Place having available
space of 150 mm or more in
front and rear of the server.
100 to 120 Vac/200 to
240 Vac parallel
bi-polar wall power
outlet with the ground
Wall outlet to connect the
supplied power cord.
Pl
op
ex
si
ace having a space enough to fully
en the front door (The front door
trudes about 35 mm from the left
de of the server when fully opened.)
To Next Page
Loading...
