3-4
Do not place the server in the following places. Placing the server in such places may cause malfunctions of the server.
Places with drastic changes in temperature (e.g., near a heater, air conditioner, or refrigerator)
Plac
Plac ioxide, hydrogen sulphide, nitrogen dioxide, chlorine, ammonia,
A
On
Plac
Plac e magnetic field (such as a TV, radio, broadcast/communication antenna,
agnetic crane) is placed (If unavoidable, contact your service
Plac
Plac
pow ch equipment, contact your service
es with strong vibration
es where corrosive gases (sulphur d
ozone, etc) exist.
nd also, places where the air (or dust) includes components accelerating corrosion (ex. sulphur, sodium
chloride) or conductive metals.
a non-anti-static carpet
es with possibilities of falling objects
es near a device generating intens
power transmission wire, and electrom
representative to request proper shield construction.)
es where a power outlet that shares the ground line with another (especially the one to which a device
with large power consumption is connected) must be used for the server
es near equipment that generates power noise (e.g., contact spark at power-on/power off of commercial
er supply through a relay). If you must install the server close to su
representative for separate power cabling or noise filter installation.
To Next Page
Loading...
