NEC Express5800 140He - Page 168

5-14
Installation of the Optional Network Board Driver
1.
Start Device Manager.
2. Click [Network adapters] and double-click [(Network Adapter Name)].
[(Network Adapter Name) Properties] appears.
NOTE: [(Intel(R) PRO/1000...)] is the name of On-Board adapter. All other names show
the Optional Network Board.
3. Click [Driver] tab and click [Update Driver...].
[Hardware Update Wizard] appears.
4. Select the [Install from a list or specific location(Advanced)] radio button and click [Next].
5. Select the [Search for the best driver in these locations] radio button and check off the [Search removable
media (floppy, CD-ROM...)] check box.
6. Check the [Include this location in the search] check box and when using [Intel Pro/1000 + - Intel Pro/1000
MT Dual – Intel Pro/1000 MF] specify
[CD-ROM driveletter:\WINNT\DOTNET\BC5\PRO1000\WS03XP32].
When using [INTEL PRO/100+], specify
[CD-ROM driveletter:\WINNT\DOTNET\BC5\PRO100\WS03XP32].
Then click [Next].
7. Click [Finish].
IMPORTANT: If you want to use optional Network Board INTEL PRO/1000 TX 64-BIT
PCI, open [Advanced] in PROSet window and change [Offload TCP Segmentation] value
to "Off".
Installing SCSI Controller Driver (Initio 101 / Adaptec 29320)
If you use SCSI controller driver (Initio 101 / Adaptec 29320), install it according to the following procedure:
1. Start [Device Manager] from [Start] menu → [Control Panel] → [Administrative Tools] → [Computer
Management].
2. Double-click the SCSI Controller driver which Device Manager lists as unknown device.
3. Click [Update Driver].
4. When the "Update Device Driver Wizard" appears, select "Install from a list or specific location [Advanced]"
and click [Next].
5. Select "Don't search. I will choose the driver to install" and click [Next].
6. Click [Have Disk..].
7. Insert "Windows Server 2003 OEM-DISK for EXPRESSBUILDER" into the floppy disk drive, enter "a:\"
into "copy manufacturer's file from:" and click [OK].
8. Specify the following driver and click [Next].
– [INITIO INI-A10XU2W PCI SCSI Controller](When Initio 101 board is installed.)
– [Adaptec SCSI Card 29320ALP - Ultra320 SCSI](When Adaptec 29320 board is installed.)
The installation of the driver is completed.
Restart the system according to the message appeared on the screen.