EasyManua.ls Logo

NEC Express5800 140He - Page 289

NEC Express5800 140He
398 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9-23
List of Optional Devices and their Available Slots
PCI PCI Express PCI-X
#1 #2 #3 #4 #5 #6 #7 #8 #9
Bus A Bus B Bus C Bus D Bus E Bus F
Description
32-bit/33MHz x4 x8 64-bit/100MHz
Slot size Full-height
PCI board type 5V x8 socket 3.3V
Available board size Long/short
Product Name
Hot-plug Non-hot-plug Hot-plug
Initio 101 SCSI controller
(32bit/33MHz PCI)
*5
– – –
Adaptec 29320 SCSI controller
(64bit/133MHz PCI-X)
*5
– – –
SCSI U160 PCI-ATX-64b SCSI controller
(64bit/133MHz PCI-X)
*5
– – –
SecuRAID 321 Disk array controller
(64bit/66MHz PCI)
*4
– – – – –
Emulex LP1050 Fibre Channel controller
(2Gbps/Optical)
(64bit/133MHz PCI-X)
*4
– – – – –
64B PCI-X PRO 1000MT
DUAL
1000BASE-T Adapter
(2ch)(64bit/133MHz PCI-X)
*1
– – – – –
INTEL PRO/1000 TX
64-BIT PCI
1000BASE-T Adapter
(64bit/133MHz PCI-X)
*1
– – – – –
INTEL PRO/1000 F
64-BIT PCI
1000BASE-SX Adapter
(64bit/133MHz PCI-X)
*1
– – – – –
: Can be installed. –: Cannot be installed.
*1 Only one card can be installed per a PCI-X bus.
*2 Up to two cards can be installed.
*3 Up to three cards can be installed.
*4 Up to four cards can be installed.
*5 Up to six cards can be installed.
NOTE: The system BIOS initialises the PCI slots in the order shown below. The order
may be changed according to the types and number of PCI cards.
PCI#3PCI#4PCI#5PCI#8PCI#9PCI#6PCI#7on-board RAID
controllerPCI#1PCI#2
Onboard LAN Controller Considerations
It is possible to configure the Teaming function of AFT (Adapter Fault Tolerance)/ALB (Adaptive Load Balancing) in a
standard network controller (on board LAN controller).
But it is also impossible to configure the Teaming function of the same AFT/ALB on a standard network controller and
an optional LAN board.
Restriction on Teaming among Onboard LANs
When teaming is configured among onboard LANs, the following system event log appears when Windows starts. You
can ignore this message and continue operation.
source: iANSMiniport
event IDs: 11/13/16/22

Table of Contents

Related product manuals