9-26
8. Slowly close the tab to secure the PCI board.
NOTE: Make sure that the tab is firmly locked. If the tab is unlocked, the PCI board
and/or I/O board may be damaged due to unstable PCI board.
9. Reinstall the removed components.
10. Turn on the power of the server. Then make sure that any error message does not appear in POST.
If an error message appears, write down the message and review the error message list in Chapter 8.
11. Start the BIOS Setup Utility to set the "Reset Configuration Data" in the "Advanced" menu to "Yes."
This is required to update the hardware configuration information. See Chapter 4 for details.
Removal
Remove the board in the reverse procedure of the installation.
To Next Page
Loading...
