9-36
Hot Replace
Use the following procedure to execute a Hot Replace:
1. Stop the device driver used by the Hot Plug PCI board you want to replace as follows:
IMPORTANT: Before removing a PCI board, be sure to stop the driver of the slot
(containing the PCI board) from the operating system. Failure to do so may cause the
system to fail.
To stop the device driver from the operating system window:
(1) Open [Add/Remove Hardware] in [Control Panel].
The [Add/Remove Hardware Wizard] starts.
(2) Click [Next].
(3) Select [Uninstall/Unplug a device] for hardware task, then click [Next].
To Next Page
Loading...
