9-39
4. Slowly insert the PCI board into the server.
5. Push the PCI board until the connection part of the board is firmly connected into the slot.
IMPORTANT: If failing to install the PCI board correctly, reinstall it. Be careful not to
apply excess force to the PCI board when handling it. Applying excess force may cause
damage to the PCI board.
NOTES:
After installed a long board, secure it with the lock on the upper part of the guide rail.
Insulators are installed between the PCI board slots.
They are for protecting the PCI boards already installed. Take care not to remove or
damage the insulator when installing or removing the PCI board. If the insulator is taken
off, reinstall the insulator in place.
6. Connect the cables to the PCI board while firmly holding the PCI board with your hand.
7. Slowly close the tab to secure the PCI board.
8. Press the PCI hot plug switch.
The PCI Slot Power lamp flashes once, and then goes on.
NOTES:
If the server runs on Windows Server 2003 or Windows 2000, the operating system
automatically recognises the installed PCI board and installs the driver.
If an error occurred in the installed board or slot, the PCI Slot Fault lamp goes on
(amber).
To Next Page
Loading...
