2-7
1 Power supply units
po DC power to the server. The factory-installed power supply units are installed in
ts e for optional power supply units in a power redundant configuration.
2 AC i
The
rd
3 d
1:
3-2: PCI-Express (x8)
:
4:
4
5 PCI
6 PCI
7 Mou
ed ouse.
8 Keyb
ed
9 in
ed
10 Seria
ria onnect the server to a device with a serial interface. The server cannot be
rec tor.
11 ria
be el.
12 Man
13 B
ed
m
14 Moni
d
15 B
d B interface.
16
ed
The the bold-faced character shows the port number.
17 K
18 0
19 C
20 c mp
21 b
The
slo
wer supply unit supplies
1 and 2, and slots 3 and 4 ar
nlet
AC inlet is connected with the power cord. Each power supply unit has one socket. Use the provided power
co
d
.
A
3-
itional PCI board slot
64bit/100MHz, hot-plug PCI-X
Hot-plug
3-3 Non-hot-plug PCI-Express (x4)
3-
PCI
32-bit/33MHz, non-hot-plug PCI
slot Fault lamp
slot POWER lamp
slot error lamp
se connector
Us to connect the optional m
oard connector
yboard.
Us to connect the optional ke
Pr
Us
ter port connector
to connect a printer with
a Centronics interface.
l port A connector
Se l port A connector is used to c
di tly connected to a leased line through this connec
Se
o
l port B connector
T used exclusively with the serial port B connector on the front pan
agement LAN Port
ICM connector
Us
nu
to connect a device having ICMB interface. The number following the bold-faced character shows the port
ber.
tor connector
Use to connect the display unit.
connector
US
Use
to connect a device with an US
LAN connector
Us to connect a network system on LAN.
number following
LIN
100
/ACT lamp
/100/10 lamp
BM error lamp
Pro essor board error la
I/O oard error lamp
To Next Page
Loading...
