G-21
5. Fix the slide rail assembly with four screws (B) (two for each of the front and rear ends) and four washers (A)
(two for each of the front and rear ends).
IMPORTANT: Make sure that the four screw holes on the rail can securely be viewed
through the angle hole when the tip of the frame on the slide rail assembly is hit on the
frame with angle holes of the rack.
Make sure that the slide rail assembly is located on the level.
6. Install the other slide rail assembly following the procedure in steps 4 and 5 above.
IMPORTANT: Make sure that the slide rail assembly is installed at the same height as
that already installed.
To Next Page
Loading...
