129

5. Using On-Screen Menu

[HDBaseT OUT SELECT]

Select signal to output from the HDBaseT OUT/Ethernet port on the projector. When two images are projected simul-

taneously (PIP/PICTURE BY PICTURE), the image for the main screen is output.

AUTO �� Output the input signal� When [PIP] has been set, the input signal for the main screen is output�

HDMI1 �� Output the input signal thru the HDMI 1 IN terminal�

HDMI2 �� Output the input signal thru the HDMI 2 IN terminal�

DisplayPort �� Output the input signal thru the DisplayPort IN terminal�

HDBaseT �� Output the input signal thru the HDBaseT IN/Ethernet port�

NOTE:

• Signal thru the COMPUTER IN terminal can not be output. In the state [PIP] or [PICTURE BY PICTURE] has been set and [AUTO]

has been set for this function, moreover, the input terminal for the main screen is the COMPUTER and the input terminal for the

sub screen is one among the HDMI 1 IN, HDMI 2 IN, DisplayPort IN terminals, or HDBaseT IN/Ethernet port, the signal from the

sub screen will be output.

• If the set input terminals for main and sub screen for [PIP] and [PICTURE BY PICTURE] are differed from the selected input

terminals, any image will be output.

• 4K60p and 4K50p signals can not be output.

[EDID VERSION]

Switch the EDID version for the HDMI 1 IN and HDMI 2 IN terminals.

MODE1 �� Supports general signal

MODE2 �� Supports 4K signal

Select this mode for displaying 4K image using the device supporting 4K

NOTE:

If image and sound can not be output in [MODE2], switch to [MODE1].

[HDCP VERSION]

Switch the HDCP version for the HDMI 1 IN, HDMI 2 IN and HDBaseT IN/Ethernet terminals.

HDCP2�2 �� Automatically switch the mode HDCP2�2 and HDCP1�4

HDCP1�4 �� Forcedly perform transmission with HDCP1�4

NOTE:

• If image and sound can not be output from the monitor connected with the HDBaseT OUT/Ethernet port, switch the HDCP version

to HDCP1.4.

NEC PA653UL User Manual

Other manuals for NEC PA653UL