17
2. Projecting an Image (Basic Operation)
Note on Startup screen (Menu Language Select screen)
When you rst turn on the projector, you will get the Startup menu. This menu gives you the opportunity to select one
of the 30 menu languages.
To select a menu language, follow these steps:
1. Use the ▲, ▼, ◀ or ▶ button to select one of the 30
languages from the menu.
2. Press the ENTER button to execute the selection.
After this has been done, you can proceed to the menu
operation.
If you want, you can select the menu language later.
(→ [LANGUAGE] on page 78 and 109)
NOTE:
• If the message, [PLEASE SET "DATE AND TIME".] is shown, please set the current date and time. (→ page 120)
• In the case this message is not shown, the [DATE AND TIME SETTING] is recommended to complete.
• Keep the lens cap off the lens while the projector’s power is on.
If the lens cap is on, it could be warped due to high temperature.
• If the STATUS indicator lights orange with the power button pressed, the projector will not be turned on since the [CONTROL
PANEL LOCK] has been ON. Cancel the lock by turning it off. (→ page 120)
• While the POWER indicator is blinking blue in short cycles, the power cannot be turned off by using the power button.
To Next Page
Loading...
Need help?
General
