NEC PH1000U - Performing Lens Calibration

17
2. Projecting an Image (Basic Operation)
2. Pressthe (POWER)buttonontheprojectorcabinet
orthePOWERONbuttonontheremotecontrol.
 ThePOWERindicatorwillturntoblueandtheprojector
willbecomereadytouse.
TIP:
• Whenthemessage“PROJECTORISLOCKED!ENTERYOUR
PASSWORD.” is displayed, it means that the [SECURITY]
featureisturnedon.(→ page 45)
• When the ECO messageis displayed, it means that [ON] is
selectedfor[ECOMESSAGE].(→ page 122)
 Afteryouturnonyourprojector,ensurethatthecomputer
or video source is turned on.
NOTE:Whennosignalisavailable,theNEClogo(default),blue,or
black screen will be displayed.
Performing Lens Calibration
Afterinstallationorreplacementofthelens,besuretoperform
[CALIBRATION]bypressingandholdingtheORIENTATION
buttonforatleasttwoseconds.Calibrationcorrectsthead-
justablezoomandfocusrange.Ifcalibrationisnotperformed,
youmaynotbeabletogetthebestfocusandzoomevenif
youadjustthefocusandzoomforthelens.
• Thefollowinglensesneedcalibration:
 NP26ZL,NP27ZL,NP28ZL,NP29ZL
Standby Blinking PowerOn
Steady orange
light
Blinking blue
light
Steady blue
light
(→page228)