NEC UNIVERGE DT310

98
TO ORIGINATE A CALL USING
SPEED CALLING (-STATION/
GROUP)
Press key.
Press the desired speed calling number.
TO ORIGINATE A CALL USING
SPEED CALLING - SYSTEM
To program Speed Calling – System key (on
one-touch speed calling key)
Press key.
Press desired One-Touch Speed Calling key. The
LCD displays previously stored digits.
Dial the “Speed Calling – System” access code and
the abbreviated call code.
Press key again.
To operate from the Speed Calling – System key
Press the “Speed Calling – System” key.
If the DT Series does not have the “Speed Calling –
System” key, dial the “Speed Calling – System”
access code, then the abbreviated call code.
To operate from the Directory key
Press key.
Dial the abbreviated call code (maximum of 4 dig-
its).
Redial
XXXXXX
LNR[ ]/SPD[_ _] –X
*
Feature
Feature
4:26 PM TUE 13 APR 2004
SPEED SET
4:26 PM TUE 13 APR 2004
XXXX
Directory
4:26 PM TUE 13 APR 2004
XXXX