NEC UNIVERGE DT310 - Call Forwarding - Dontanswer

113
CALL FORWARDING - DON’T
ANSWER
To Set
Press key. Receive dial tone.
If setting for another station, press
MULTILINE
APPEARANCE
.
Press FWD-NA or dial “Call Forwarding – Don’t
Answer” access code. Receive special dial tone.
Dial destination station or external telephone num-
ber. Receive service set tone.
FWD-NA LED lights (at your station or at the DT
Series of the multiline station you are setting).
Press key. Call Forwarding – Don’t Answer
is set.
Using the Soft Key
Press FDN Soft Key. Receive special dial tone.
Dial destination; wait for service set tone.
“FORWARD SET” is displayed; Call Forwarding –
Don’t Answer is set.
To Verify (only for terminal with LCD)
If verifying for another station, press MULTILINE
APPEARANCE while idle.
Press FWD-NA.
Display indicates the station number calls are for-
warded to.
Note 1: Call Forwarding for Busy Line and Don’t Answer
may be combined depending upon system pro-
gramming.
Note 2: With Soft Key operation, FDB flashes on the dis-
play.
To Cancel
Press key. Receive dial tone. If canceling
for another station, press MULTILINE APPEAR-
ANCE.
Press FWD-NA or dial "Call Forwarding - Don't
Answer" cancel code. Receive service set tone.
4:26 PM TUE 13 APR 2004
FORWARD CANCEL
MIC >>>
Speaker
Speaker
Forwarding
station
4:26 PM TUE 13 APR 2004
FORWARD SET 2000
4:26 PM TUE 13 APR 2004
FORWARD SET
MIC >>>
Forwarding
station
4:26 PM TUE 13 APR 2004
FORWARD 2000
Speaker