NEC UNIVERGE DT310

76
TO LOGIN
When login mode is activated, following procedure is
required.
Enter login code and press Set soft key.
(Station number is used as the Login code.)
Enter the password and press OK Soft key.
If the login code is accepted, display changes to
normal idle status.
TO LOGOUT
Press the preassigned Logout Feature Key on the
terminal.
“LOGOUT?” is displayed on the LCD of the termi-
nal.
Press the Logout Feature Key on the terminal
again.
TIP:
This feature is only available for DT700 Sereies.
Password
Login ID 2000
:
:
Cancel BK Set OK
2000
Cancel BK Set OK
*****
Password
Login ID
:
:
MIC DND >>>
15:39 AM MON 18 JUL 2007
TIP:
This feature is only available for DT700 Sereies.
TIP:
This location is an example.
TIP:
Logout button is assigned by data setting at the
ECP (Enterprise Communication Platform).
MIC DND >>>
15:39 AM MON 18 JUL 2007
L-OUT >>>
15:39 AM MON 18 JUL 2007
LOGOUT ?