VM8000 Issue 1.0
InMail System Guide 2 - 73
11. Enable callers to access Directory Dialing from a Dial Action Table action.
Make sure you have an action in the active Dial Action Table that is a GOTO to
the Directory Dialing Mailbox.
See Dial Action Table on page 2-63 for more.
By default, no actions are assigned as a GOTO to a Directory Dialing Mailbox.
Use a Call Routing Mailbox for Directory Dialing
1. Set up the Directory Dialing Mailbox.
47-03-02 Call Routing Mailbox Number
Enter the mailbox number for the Call Routing Mailbox. This number must
correspond to a Department Group pilot number set up in 11-07-01
Department Group Pilot Numbers.
When using a Call Routing Mailbox as an additional resource (for example,
as an extra Directory Dialing Mailbox), you can perform the following
actions:
H
Assign a pilot number to an unused Department Group in 11-07-01
Department Group Pilot Numbers.
H
Set up the Call Routing Mailbox in 47-03 using this pilot number.
H
When 47-03 programming is complete, remove the pilot number
assignment in 11-07-01 Department Group Pilot Numbers.
By default, no Call Routing Mailbox numbers are assigned.
47-03-03 Call Routing Mailbox Type (Mailbox Type)
Enter 3 to make the selected Call Routing Mailbox a Directory Dialing
Mailbox.
By default, all Call Routing Mailboxes are set up as Call Routing Mailboxes (1).
2. Set up the name programming and enter names.
47-01-16 Name Format (Name Format)
Determine how extension names should be entered in 15-01-01 Extension
Name or via the telephone. The options are 0 (first name followed by last
name) or 1 (last name followed by first name).
By default, the system expects names to be entered as first name followed by last
name (0).
15-01-01 Extension Name (Ext Name)
Enter the name for each extension. The format you use should follow the
setting of 47-01-16 Name Format.
By default, no names are entered.
To Next Page
Loading...
