NEC Univerge SV8100 VM8000 InMail - Time and Date

VM8000 Issue 1.0
InMail System Guide 2 - 237
Time and Date
Description
Since VM8000 InMail is completely integrated with the telephone system software,
the VM8000 InMail time and date is the same as the phone system time and date.
Since time and date is used on telephone displays and with the Auto Time Stamp and
Time and Date Stamp features, be sure to set it accurately. To change the time and
date, use the system programmable options. See Programming below. The Time and
Date is retained if the telephone system power should fail or the system resets.
In addition, a Subscriber Mailbox user can hear the time and date when they call their
mailbox.
Related Features
Auto Time Stamp
After a user listens to a message, VM8000 InMail can optionally announce the time and
date the message was left.
Time and Date Stamp
An extension can listen to a message and dial TI to hear the time the message was sent.
Programming
1. To set the system time and date from system programming:
 10-01-01 Time and Date
Set the system Time and Date.
2. To set the system time from a system telephone:
N Press Speaker key.
N Dial 728.
N Dial two digits for the hour (24 hour clock, 13 = 1:00 PM).
N Dial two digits for the minutes (00-60).
N Press Speaker to hang up.