VM8000 Issue 1.0
InMail System Guide 2 - 103
Forced Unscreened Transfer
Description
A Subscriber can optionally convert Automated Attendant Screened Transfers to
Unscreened Transfers by enabling this option in the Mailbox user interface.
J
Calls from the Automated Attendant ring like other transferred calls and display
the incoming Caller ID data (if provided by telco and enabled in programming)
as the call is ringing.
J
As with Screened Transfers, unanswered calls route to the subscriber’s greeting
(recorded or default) so the caller can leave a message. However, with
Unscreened Transfer the caller cannot dial 2 to reach the Next Call Routing
Mailbox options (if programmed).
Related Features
Dial Action Table
If enabled in the Subscriber Mailbox, VM8000 InMail automatically converts any Screened
Transfers (TRFs) to the subscriber’s extension to Unscreened Transfers (UTRFs).
Screened Transfer
After the Automated Attendant caller dials an extension, VM8000 InMail calls (screens)
the destination extension to see if the transfer can go through.
Unscreened Transfer
After an Automated Attendant caller dials an extension, VM8000 InMail immediately
transfers the call to the extension and hangs up.
Programming
1. Enable Forced Unscreened Transfer for the Subscriber Mailbox.
47-02-10 Forced Unscreened Transfer (Forced UTRF)
Enter 1 (Yes) to enable this option to automatically convert Automated
Attendant Screened Transfers to Unscreened Transfers.
By default, this option is disabled (0).
To Next Page
Loading...
