VM8000 Issue 1.0
InMail System Guide 2 - 43
Auto Time Stamp
Description
After a Subscriber Mailbox user listens to a message, VM8000 InMail can optionally
announce the time and date the message was left. The Subscriber can enable Auto
Time Stamp from their mailbox, or you can optionally enable in from system
programming. Auto Time Stamp helps if the subscriber needs to know the time and
date of each message they receive without taking any extra steps. With Auto Time
Stamp turned on, VM8000 InMail automatically announces the date, time, and
(optionally) the caller’s number at the end of each message. With Auto Time Stamp
turned off, the subscriber must dial
TI (84) while listening to a message to get the
same information.
Related Features
Mailbox Options Menu
Auto Time Stamp is available on the Mailbox Options Menu.
Time and Date
VM8000 InMail uses the VM8000 InMail Time and Date.
Time and Date Stamp
An extension can listen to a message and dial a code to hear the time the message was
sent.
Programming
1. Enable Auto Time Stamp from your Subscriber Mailbox.
Refer to Operation on page 2-44.
2. Optionally Enable Auto Time Stamp from System Programming.
47-02-11 Auto Time Stamp
Enter 1 (Yes) to enable Auto Time Stamp.
By default, Auto Time Stamp is disabled (0).
To Next Page
Loading...
