NEC Univerge SV8100 VM8000 InMail - Set Up Automated Attendant to Answer Outside Calls

Issue 1.0 VM8000
1 - 6 Quick Setup
H You can optionally use 15-07-01 Programming Function Keys to assign a Voice
Mail programmable key (code 77).
H If you don’t assign the Message key or a programmable key for Voice Mail access,
an extension user can access his mailbox by the following actions:
Ì Press Speaker key
Ì Dial VM8000 InMail pilot number
Ì Dial mailbox number
SECTION 7 SET UP AUTOMATED ATTENDANT TO ANSWER OUTSIDE CALLS
To enable Automated Attendant to answer outside calls, set up Direct Inward Lines
(DILs) and terminate them to VM8000 InMail.
Automated Attendant enables the following capabilities:
J All calls are answered by Call Routing Mailbox 1 and Dial Action Table 1. This
happens because:
H Answer Table 1 Runs Monday-Friday from 8:30AM to 5:00PM, and uses Call
Routing Mailbox 1.
H At all other times, the Default Mailbox answers – also using Call Routing Mailbox 1.
J Dial Action Table 1 allows outside callers to perform the following actions:
H Dial system extensions (if installed).
H Dial 0 for an operator (extension 101).
H Dial * + Extension to leave a Quick Message in a mailbox.
H Dial # + Extension to remotely log on to their mailbox.
H Wait on the line to be automatically routed to the operator.
To Set up the Automated Attendant to answer outside calls:
1. Set up trunks as Direct Inward Lines.
 22-02-01 Incoming Call Trunk Setup
Assign Service Type 4 to each trunk you want to be a DIL. Make a separate
entry for each Night Service mode.
 By default, trunks are Service Type 0 (Normal).