Issue 1.0 VM8000
2 - 78 Features
Dialing Options Available while Entering a Name
The following table shows the dialing options available to the caller while they are
entering a name into a Directory Dialing Mailbox.
J
By default, the caller can dial the digits 2~9 to enter the name or dial # to return
to the Automated Attendant.
J
If a Next Call Routing Mailbox is specified, the caller can dial the digits 2~9 to
enter a name, dial 0 to follow the 0 action of the Next Call Routing Mailbox, or
dial # to route directly to the Next Call Routing Mailbox.
Directory Dialing Mailbox Name Entry Options
(Options available while entering a name)
Dialed
Digit
47-14-08 or 47-15-08:
Next Call Routing
Mailbox Setting
Action
1 Not applicable Entry is ignored.
2~9 Not applicable Interprets the digit as a letter and waits about 20
seconds for additional input (i.e., more letters or a
# to conclude name entry). If no additional digits
are dialed for 10 seconds, the Directory Dialing
Message repeats and then VM8000 InMail hangs
up.
0 UND (Not assigned) Repeats the Directory Dialing Message (to make
a new name entry) each time the caller dials the
digit.
1-32 (valid Call Routing
Mailbox)
Caller routes according to the 0 action of the Next
Call Routing Mailbox’s Dial Action Table.
* Not applicable Repeats the Directory Dialing Message (to make
a new name entry) each time the caller dials the
digit.
# UND (Not assigned) Routes to the Automated Attendant (i.e., back to
the Call Routing Mailbox that initially answered
the call).
1~32 (valid Call Routing
Mailbox)
Routes to the Next Call Routing Mailbox and
plays that mailbox Instruction Menu.
Timeout UND (Not assigned) Repeats the Directory Dialing Message (to make
a new name entry) up to two times and then
hangs up.
To Next Page
Loading...
