Issue 1.0 VM8000
2 - 248 Features
Programming
1. Assign the UTRF action to a key on the active Dial Action Table.
47-13-01 Dial Action Tables: UTRF Action - Unscreened Transfer (2) (UTRF)
Normally, the corresponding Number option should be XXX. Note that the
key you choose for this action is the first digit of the called extension
number.
H
For example, to allow callers to place Unscreened Transfers to
extensions 101~199, for key 3 enter UTRF for the Action and XXX for
the corresponding Number.
To have Unscreened Transfer call a specific extension, the corresponding
Number option should be that extension’s number. The caller then dials that
single digit to reach the extension.
H
For example, to have callers dial 8 to reach extension 303, for key 8
enter UTRF for the Action and 303 for the corresponding Number.
By default, key 0 and TIMEOUT are both UTRF actions to 101. In addition, key 3
is an UTRF action to XXX.
2. Optionally set the telephone system’s Transfer Recall interval.
24-02-04 Transfer Recall Time
Unanswered Unscreened Transfers route to the extension’s mailbox after
this interval.
By default, this interval is 30 seconds.
Operation
Not applicable
To Next Page
Loading...
