Issue 1.0 VM8000
2 - 48 Features
3. Set up the Answer Tables.
Turn to Answer Tables on page 2-29 for more.
By default, all trunks use Answer Table 1. Answer Schedule 1 is active and runs
continuously.
4. Set up the Call Routing Mailboxes.
Turn to Routing Mailbox on page 2-211 for more.
The active schedule (Answer Table 1, Answer Schedule 1) uses Call Routing Mailbox 000.
5. Set up the Dial Action Tables.
Turn to Dial Action Table on page 2-63 for more.
By default, Call Routing Mailbox 000 uses Dial Action Table 1.
6. Set the maximum message length for Automated Attendant callers leaving a
message in a mailbox.
47-01-03 Subscriber Message Length (Subs Msg Length)
This sets the maximum message length (1~4095 seconds) for outside
Automated Attendant callers accessing a mailbox via a LOGON or GOTO
command.
The default setting is 120 seconds.
47-01-04 Non-Subscriber Message Length (Mbox Msg Length)
This sets the maximum message length (1~4095 seconds) for outside
Automated Attendant callers leaving a message in a Subscriber Mailboxes.
The default setting is 120 seconds.
Operation
Using the Automated Attendant
For the outside caller:
After Automated Attendant answers, voice prompts will instruct you which digits to dial.
To Next Page
Loading...
